Breaking Torque Handles

breaking torque handlesBreaking Torque Handles TBN

These tools have to be Pre-Set to the required torque value using a calibration analyser or, by using the scale provided on the tool for calibrated models.

When the required torque value is achieved during tightening, the tools ‘Breaks’ as a signal to the Operator. This significantly reduces the possibility of over-tightening.

 

Model

End Fitting

       

N·m

lbf·in

TBNS 2

8mm Diameter Spigot Type

048800

0.2 - 2.0

1.8 - 18

133

5.24

135

4.8

TBNS 10

8mm Diameter Spigot Type

048900

1.0 - 10

9.0 - 89

133

5.24

135

4.8

TBN 25 E

16mm Diameter Spigot Type

050000

5.0 - 25

44 - 221

265

10.44

405

14.3

TBN 25 EG

9x12 Rectangular Cavity German Type

050010

5.0 - 25

44 - 221

265

10.44

405

14.3

TBN 25 EW

Wedge Type (Dovetail)

050030

5.0 - 25

44 - 221

265

10.44

405

14.3

TBN 65 E

16mm Diameter Spigot Type

050100

10 - 65

89 - 575

302

11.9

750

26.5

TBN 65 EG

9x12 Rectangular Cavity German Type

050110

10 - 65

89 - 575

302

11.9

750

26.5

TBN 65 EW

Wedge Type (Dovetail)

050130

10 - 65

89 - 575

302

11.9

750

26.5

TBN 135 E

16mm Diameter Spigot Type

050200

20 - 135

177 - 1195

408

16.10

1030

36.4

TBN 135 EG

9x12 Rectangular Cavity German Type

050210

20 - 135

177 - 1195

408

16.10

1030

36.4

TBN 135 EW

Wedge Type (Dovetail)

050230

20 - 135

177 - 1195

408

16.10

1030

36.4

* The preferred and certified ranges of these tools is in accordance and exceeds the requirements of ISO 6789:2003. (Repeatability ± 4% of reading for tools above 10 Nm and ± 6% of reading for tools less than 10 Nm).

* Approved for use in Electrostatic Discharge Protected Areas.